Would it be too much trouble to trouble you on a brief step by step procedure on how to use the ARE to modify the size and content of a panel?
And mot importantly how to copy and/or backup the panel(s) to a safe place before attempting an ARE modification. Regards, Michael Senack -----Original Message----- From: Bob Looney [mailto:[EMAIL PROTECTED]] Sent: Thursday, November 28, 2002 12:17 AM To: [EMAIL PROTECTED]; [EMAIL PROTECTED] Subject: RE: [mfg-smartcam] Add Process Step I have used the ARE extensivly to modify the size and content of most of my panels, as well as the content of my job planner. It is a very nice tool for moving the location of the tokens within the panels also. bob >From: [EMAIL PROTECTED] >To: [EMAIL PROTECTED] >Subject: RE: [mfg-smartcam] Add Process Step >Date: Wed, 27 Nov 2002 08:27:28 -0500 > >Jeff, > > > >You are missing the SmartCAM Localization tool Kit (SLK), which contains >the >Application Resource Editor (ARE). This utility was intended to allow third >parties to translate SmartCAM into different languages. Prior to the >discontinuance of tech support for SmartCAM by SDRC, the SLK was not >readily >available, even to resellers, due to the potential tech support nightmare >it >could create. I attained a copy from a reseller (with SDRC's permission) >with the understanding that I would never, NEVER, EVER ask any support >questions even remotely related to the SLK. This point is now moot since >EDS >(who bought SDRC) provides no technical support for any SmartCAM questions. > >This utility will not enable you to "add" anything to the "Add Process >Step" >or other dialogs, but it would allow you to change the existing strings >within. In your case you could change the "Op Type" of "Edge Milling" to >"Thread Milling". The ARE does this by making a modified copy of the >applications Binary Resource Configuration (BRC) file. Then using the ARE >you can replace one string with another. > > > >I would not recommend it's use to anyone but experienced power users. > >I would like to post it to the group, or perhaps on SmartCAM Mike's web >site, but I will need an OK from EDS first since it is copyrighted >material. > > > >============================================= > Fred Lauzus, CAM Programming Coordinator > High Steel Structures, Incorporated > mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> >http://www.highsteel.com <http://www.highsteel.com/> >============================================= > > >-----Original Message----- >From: Jeff [mailto:[EMAIL PROTECTED]] >Sent: Tuesday, November 26, 2002 11:32 PM >To: Smartcam User Group >Subject: [mfg-smartcam] Add Process Step > > >My question is in the Job Plan / Add Process Step / Milling Operations. >In the Operation Type and Tool Type I would like to add Thread Milling. >I've editted the m_inch.def, mautodsc.fmt, mautoid.fmt and just about every >file >I could find that pertains to the steps but it still doesn't show up when I >open SC. >Can this be done? What am I missing? > >Jeff Pieper >EATON Hydraulics > > ><< mic2.bmp >> _________________________________________________________________ Protect your PC - get McAfee.com VirusScan Online http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963 ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
