Good morning Bill, all. Your CTG consists of two profiles. Attached is a single profile version of your counterbore that behaves better with ShowCut.
ShowPath is a little more forgiving where CTG's are concerned. Hope that helps. - John Gent ----- Original Message ----- From: "Bill Payter" <[EMAIL PROTECTED]> To: "SmartCAM Users" <[EMAIL PROTECTED]> Sent: Sunday, January 26, 2003 4:34 AM Subject: [mfg-smartcam] Show Cut & Show Path > Hi guys, > > See attached CTG drawing of a combination drill/counterbore which is > 8,5mm/16mm diameter. It is drawn with the drill point below Y zero and with > the counterbore at Y zero because that is where the tool length is set.. > > I'm using Free-Form, the tool shows correctly in Show Path but not correctly > in Show Cut. > > Is this normal? > > Regards, > > Bill in the UK. >
TOOL10.sh3
Description: Binary data
