I've found that sometimes the line at the top of your tool (the line from the large dia. to X0.0) seems to cause the problem. Remove it and see if that helps. I would try it for you but I am using Adv. Milling 11.1. When I have the problem you are describing I don't see the tool at all or it looks like the tool described as if I didn't even call for a ctg. Hope this helps.
Robert Manganello K.B.A. North America York Pa. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Bill Payter Sent: Sunday, January 26, 2003 7:35 AM To: SmartCAM Users Subject: [mfg-smartcam] Show Cut & Show Path Hi guys, See attached CTG drawing of a combination drill/counterbore which is 8,5mm/16mm diameter. It is drawn with the drill point below Y zero and with the counterbore at Y zero because that is where the tool length is set.. I'm using Free-Form, the tool shows correctly in Show Path but not correctly in Show Cut. Is this normal? Regards, Bill in the UK. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
