[mfg-smartcam] Macro question

[gary]

I am finding myself doing the same task over and over again.   Unfortunaly I am not very skilled in creating macros.   Any help, pointers or samples would be greatly appreciated.   I would like to create a macro to do the following.       @@@   Start macro   prompt for geometry (profile) selection   (select geometry)   match layer, tool, step, offset, geometry direction   Insert a line before the selected geometry (prompt for length, angle, and the Z starting level )   add a lead in before the line ( 1 mm 45 Deg  a prompt would be nice )   add "@compl" before the lead in   go to the end of the complete profile   add a exit line (prompt for length and angle)   End of macro   @@@     The ultimate would be to apply the above to every profile in a selected group.   Can this be done ?     Thank you for your time.     Regards, Gary