[mfg-smartcam] Macro help

[gary]

The first part of the macro is working thanks to everybody's input.   Now I want to add a short lead out line to the grouped geometry.   The macro works on regular geometry but not on a helix.   Therefore I need to add a short line in the macro.   Currently the macro adds a line after the initial element.   How can I force the macro to go to the end of the group.   Thank you for everybody's input.         WHILE( GRP(0)<=0)    PAUSE[TX="ERROR: You have not selected any geometry!", PT=1]   // If no geometry is selected this loop loops continuously until you select cancel   GRAPHICS_ON[]   ENDW   VAR_REMOVE_ALL[] #elmt=GRP(1)   ELMT_SEQ[BA=0, EL=#elmt, ME=1]   LINE[XE=STX(#elmt), YE=STY(#elmt), ZE=STZ(#elmt), AN=0, DS=5, SE=2, SS=2]   MOD_LINE[EL=#elmt, XS=STX(#elmt), YS=STY(#elmt), ZS=STZ(#elmt)+1, XE=ENX(#elmt),   YE=ENY(#elmt), // This will alter the Z start point by + 1 mm  ZE=ENZ(#elmt), SE=2, SS=2] // This will alter the Z start point by + 1 mm   LEAD_IN[EL=#elmt, AN=45, DS=1, LC=0, TY=0, CS=0, RP=0, MO=0]   PROF_SEQ[BA=0, EL=#elmt, ME=1] UEVENT[XS=STX(SEQEL()), YS=STY(SEQEL()), LV=STZ(SEQEL()), TX="@CMPL"]   // ELMT_SEQ[BA=1, EL=#elmt, ME=1] // Lead out works on regular geometry Dose not work for   Helix   // LEAD_IN[EL=#elmt, AN=90, DS=1, LC=1, TY=0, CS=0, RP=0, MO=0] // Lead out works on regular   geometry Dose not work for Helix    VAR_REMOVE_ALL[]  #elmt=GRP(1)   // PROF_SEQ[BA=1, EL=#elmt, ME=1]  // Not working yet   // LINE[XS=ENX(#elmt), YS=ENY(#elmt), ZS=ENZ(#elmt), AN=180, DS=2, SE=2, SS=2]  //  Not  working yet         Regards, Gary