I assume you are referring to the tool check distance that is set by SMF question 83. This value is held in template variable #CHKD. You could try re-evaluating this value in your template file.
@START #EVAL(#CHKD=0) I'm not sure if it will be in effect immediately if at all. ================================================== Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ================================================== -----Original Message----- From: Benz H. Babecki [mailto:[EMAIL PROTECTED] Sent: Wednesday, September 10, 2003 7:46 AM To: Smartcam forum Subject: [mfg-smartcam] Advanced turning question Is there a way to force the "clearance" to default to "off" or zero instead of .1000" at start-up? I am using Advanced Turning, version 11. Benz Babecki Kingsbury, Inc. 10385 Drummond Rd. Philadelphia, PA 19154-3884 215-824-4985 mailto:[EMAIL PROTECTED] http://www.kingsbury.com Kingsbury Inc ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
