bob
From: "Jeremy Noland" <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] Subject: [mfg-smartcam] LINE DIRECTION Date: Thu, 13 Nov 2003 06:34:16 -0800
Hi all,
After importing your model wire frame you can pick the lines of the model and do a wall offset to use as your tool path, my question is how do you get the direction of all the lines to go in one direction if you have multiple lines going opposite directions? I've done it before but I seem to be having a brain block on how to do it.
Thanks,
Jeremy
====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
Bob Looney CNC Machine and Design LLC P.O. Box 1405 250 SE Timber Ave. Redmond, OR. 97756 541-350-7809 503-296-2544 FAX
_________________________________________________________________
Great deals on high-speed Internet access as low as $26.95. https://broadband.msn.com (Prices may vary by service area.)
====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
