RE: [mfg-smartcam] Off topic, peck drilling

[Mike Sharp]

Title: Off topic, peck drilling

This is what works for us. The “Q” is the peck   G83 Z-2.0 Q5000 F0.01 R0.0   But I seem to remember that we had to change a parameter to get the tool to retract out of the hole for each peck.     Mike   From: Stannard, Rick [mailto:[EMAIL PROTECTED] Sent: Friday, December 12, 2003 10:29 AM To: 'Smartcam Forum' Subject: [mfg-smartcam] Off topic, peck drilling   Hi all,   I have a co-worker that is using a Fanuc 0T control for his lathe.  He wants to use the peck cycle( G74?)  but can't figure out how to make it pull out of the part after each peck.  It only does a chip break at the bottom.  If anybody knows if there is a solution, I would be most grateful.   Thanks   Rick Stannard CNC Programmer 3000 W. Lomita Blvd. Torrance, CA. 90505 (310)784-4394 [EMAIL PROTECTED]