In your template file. Take the conditional brackets (<>) off the "Q".
example: Before-- < #ABSI>< G83>< #RTNLVL> X#XPOS Y#YPOS < Z#ZDPTH>< R#ZCHK>< Q#PECK><F#FEED> After -- < #ABSI>< G83>< #RTNLVL> X#XPOS Y#YPOS < Z#ZDPTH>< R#ZCHK> Q#PECK<F#FEED> John -----Original Message----- From: Chad Seelbinder [mailto:[EMAIL PROTECTED] Sent: Wednesday, March 03, 2004 11:08 AM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] mfg-smartcam I have a really simple problem that I hope there will be an easy answer for. When I code out a peck drilling cycle (G83) I have a default peck value of .100 (Q0.100). the problem is when I go to the next hole, It leaves the peck value out, and my controller doesn't see it as the default. Is there any way to make it code out the q value every time, even if is the same as the last time??? I tried to change smf question #5 to #2 and it didn't work. Any ideas????? Thank You Chad Seelbinder BETTER WIRE PRODUCTS INC. 1255 NIAGARA STREET BUFFALO, NEW YORK 14213 PHN#716-883-3377 FAX#716-883-5075 DEDICATED TO SUPERIOR QUALITY AND SATISFACTION ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
