RE: [mfg-smartcam] mfg-smartcam

[Stannard, Rick J.]

In your tmp file, find the @FXD5 cycle and remove the chevrons from around the Q#xxxx  whatever it may be on yours.  Chevron's are the  <  > symbols. This should do it.   Rick -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Chad Seelbinder Sent: Wednesday, March 03, 2004 8:08 AM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] mfg-smartcam        I have a really simple problem that I hope there will be an easy answer for. When I code out a peck drilling cycle (G83) I have a default peck value of .100 (Q0.100). the problem is when I go to the next hole, It leaves the peck value out, and my controller doesn't see it as the default. Is there any way to make it code out the q value every time, even if is the same as the last time??? I tried to change smf question #5 to #2 and it didn't work. Any ideas?????   Thank You Chad Seelbinder     BETTER WIRE PRODUCTS INC. 1255 NIAGARA STREET BUFFALO, NEW YORK 14213 PHN#716-883-3377 FAX#716-883-5075   DEDICATED TO SUPERIOR QUALITY AND SATISFACTION