Rear engine seal (I hope). Oil coming from the weep hole in the bell housing. I'm half a quart down right now on the engine oil so I am assuming that is it. I guess we will find out when we pull it.
Definitely not CAS o-ring (recently replaced) due to the weep hole leak. On Fri, Jun 20, 2008 at 10:46 PM, Ray Ayala <[EMAIL PROTECTED]> wrote: > Rear engine seal or front trans seal? (or CAS o-ring?) > > ----- Original Message ----- > *From:* Robert McElwee <[EMAIL PROTECTED]> > *To:* miatapower List <[email protected]> > *Sent:* Friday, June 20, 2008 2:07 PM > *Subject:* Tips for Installing a new rear main seal ??? > > My oil leak is getting a little worse and I think I am close to pulling the > seal and replacing it. I have had a new seal laying around forever but have > been too lazy to pull the tranny and do the work. I know how to pull the > tranny but anyone have tip for pulling the seal or replacing it? Just > looking for any little tricks you guys may have up your sleeve... > > > -- > Robert McElwee and Blue Flash > "The 40 MPG Miata" > www.lightweightmiata.com/mpg > > Lightweight Miata Forum: > www.lightweightmiata.com/forum > > The Miata Trailer Project: > www.lightweightmiata.com/trailer > > ------------------------------ > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > -- Robert McElwee and Blue Flash "The 40 MPG Miata" www.lightweightmiata.com/mpg Lightweight Miata Forum: www.lightweightmiata.com/forum The Miata Trailer Project: www.lightweightmiata.com/trailer
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
