I am cutting a window in my kitchen/living room wall to open up the kitchen
a bit. The wall runs parallel with the joists in the attic but I am puzzled
by the section on the left with four 2x4's joined together and on the right
with two 2x4's joined together. If I go into the attic there is a set of
three 2x4's starting above the four 2x4's in the kitchen that is running
perpendicular to the joists in the attic. I'm sure I can just open my hole
up a bit and install framing above/below my "window" to support this
(perhaps hire an expert to do this) but I just wanted a quick 6:00 on Sunday
morning second opinion on this. Also, if I cut some of the other vertical
2x4's out of the way and frame them in a bit as a temporary measure it
shouldn't hurt anything should it?

Picture of area in question:
http://www.lightweightmiata.com/misc/loadbearingwall.jpg




-- 
Robert McElwee and Blue Flash
"The 50 MPG Miata"
www.lightweightmiata.com/mpg

Lightweight Miata Forum:
www.lightweightmiata.com/forum

The Miata Trailer Project:
www.lightweightmiata.com/trailer
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to