If you connnected it with a splice, did you use crimp connections or solder? They have to be crimps. Solder does not work on the stainless steel wire.
Ken Bogart ----------------------------------------------------- 96 Montego Blue FFS Coldside (His) 97 Black & Tan (Hers) 90 Crystal White (sons) ------------------------------------------------------ http://www.miatacare.com http://www.cincimiata.com http://www.miatagathering.com On Sun, May 31, 2009 at 2:24 PM, Ray Ayala <[email protected]> wrote: > Does the sensor heater have power? > > ----- Original Message ----- > From: FuZaVue > To: [email protected] > Sent: Sunday, May 31, 2009 11:21 AM > Subject: P1141 Rear Oxygen Sensor Code > Hey Gang, Just got back from Iraq recently and acquired a Black 99 Miata > to cruise around in, the only issue that i have not been able to figure > out yet is the CEL keeps popping on and I get the code P1141 for the rear > Oxygen sensor. I had it replaced at a shop but with an aftermarket O2 > sensor. The mechanic in my unit is convinced that the light is not going > off because it's an aftermarket sensor. > > Has anyone had to deal with this particular issue? > > > Any new ideas would be really helpful > > > CPL A > > -- > Http://www.youtube.com/fuzavue > > ________________________________ > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
