ok got it, I wasn't reading that the 2P -> 2R wire moved was the NB O2 wire + it still would work after the cut. Steve
On Tue, May 3, 2011 at 9:16 PM, Stephen Rigley <[email protected]> wrote: > Yep, its a mk2, > Thanks > > > On Tue, May 3, 2011 at 8:01 PM, Stephen Rigley <[email protected]> wrote: > >> Thanks Sam, I'm 90% sure its a mk2 , will double check in the next hour. >> >> >> On Tue, May 3, 2011 at 7:51 PM, Sam Sharp <[email protected]> wrote: >> >>> Is it a Mk 1 Link or a Mk 2? The procedure is different. Do not cut the >>> trace if it is a Mk 1. The narrow band O2 sensor won't be used. There are >>> instructions on the FM site depending on the wideband you're using. Again, >>> if you have a Mk 1 Link the wiring will be different. I can help with this >>> when I get home and can look at how I did it, with much help from Bill >>> Cardell. >>> >>> Sam >>> >>> >>> On Tue, May 3, 2011 at 12:30 PM, Stephen Rigley <[email protected]>wrote: >>> >>>> Hi All, >>>> >>>> With 90-93 link ECU's, when you install a WideBand (+ cut the trace on >>>> the PCB), which pin does one now wire the NarrowBand signal to? >>>> >>>> Many thanks, >>>> Steve >>>> >>>> _______________________________________________ >>>> Miatapower mailing list >>>> [email protected] >>>> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower >>>> >>>> >>> >> >
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
