I've never done it but I'm sure you will get disconnected but any reachability issues will be temporary. Until arp happens, times out of gets cleared.
You can do all ports by changing ether1 to [find]. /int ethernet reset-mac-address [find] You can issue this remotely. Also you can do the same thing with Winbox. There's a reset Mac button in the interface. Justin Miller VA SkyWire, LLC 1707 E Main St Richmond, VA 23223 Office: (804) 521-4212 Desk: (804) 591-0500 ext 101 Fax: (804) 591-1559 [email protected] The information contained in this electronic message from VA SkyWire, LLC is privileged, confidential, or otherwise protected from disclosure. It is intended only for the use of the individual or entity named above. If you are the intended recipient of this message, you are hereby notified that you may not forward, distribute, copy or disclose the contents of this email without notifying the sender of this email. If you are not the named addressee, then any disclosure, copying, publication, distribution, or other use of the contents of this electronic message is strictly prohibited.. If you have received this communication in error, please notify Scott Coonfield at (804) 521-4212 or by return e-mail to [email protected], and purge the communication immediately without making any copy or distribution. Thank You. > On Nov 5, 2014, at 2:12 PM, RickG <[email protected]> wrote: > > Chuck, Is that a disruptive command? > >> On Wed, Nov 5, 2014 at 8:14 AM, Chuck Hogg <[email protected]> wrote: >> /int ethernet reset-mac-address ether1 >> That will restore the mac address to it's manufacturer default. >> >> You might want to look at export compact (which is by default now since v6) >> that doesn't copy over the MAC addresses. >> http://wiki.mikrotik.com/wiki/Manual:Configuration_Management >> >> >> Regards, >> Chuck >> >>> On Wed, Nov 5, 2014 at 6:46 AM, Bob Pensworth-Lists >>> <[email protected]> wrote: >>> I restored files from a RB-450UP to a second RB-450UP >>> >>> and the MAC addresses for all ports copied to the second >>> >>> RB-450UP. I've never had this happen before. What is the >>> >>> fix? I upgraded both devices to ROS v6.20. LAN ports >>> >>> on both devices are also flapping every connected at the >>> >>> comm site to the RB-450UP work just fine. >>> >>> >>> >>> -- >>> >>> Bob Pensworth, WA7BOB | General Manager >>> >>> CresComm WiFi, LLC | Crescent Key | Peninsula Lions Club >>> >>> Serving Washington's Coastal Counties Since 1985 >>> >>> (360) 642-0858 | WISPA Principal Member >>> >>> >>> >>> >>> _______________________________________________ >>> Mikrotik-users mailing list >>> [email protected] >>> http://lists.wispa.org/mailman/listinfo/mikrotik-users >> >> >> _______________________________________________ >> Mikrotik-users mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/mikrotik-users > > > > -- > -RickG KyWiFi > _______________________________________________ > Mikrotik-users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/mikrotik-users
_______________________________________________ Mikrotik-users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/mikrotik-users
