If by related you mean bridged or set as master port, no, they are not.
ether2-switch2 is the master port of the "LAN" side and wan2 is on it's
own interface w/ no master port. The default route is shown below.
/ip route
comment=WAN2 distance=1 gateway=xxx.xxx.xx.x \
routing-mark=to_WAN2
On 12/7/2016 11:24 AM, Ethan E. Dee wrote:
> Is the gateway reachable through the in interface of the mikrotik.
> Is the ether2 switch2 in any way related to wan2? Because it could be
> looping the traffic.
> Are your default routes in tact?
>
> On 12/07/2016 10:15 AM, Hexis via Mikrotik-users wrote:
>> I am doing some work on a small fixed wireless network, and they have 2
>> connections, neither of which are fiber. They are attempting to push
>> most of the streaming traffic out one provider while allowing everything
>> else to go through the other. I implemented routing marks based off of
>> an example in the Mikrotik wiki in order to accomplish that, marking
>> based on layer7 regex for example:
>>
>> Code: Select all
>> /ip firewall mangle print
>> add action=mark-routing chain=prerouting comment=Facebook disabled=no \
>> in-interface=ether2-switch2 layer7-protocol=facebook
>> new-routing-mark=\
>> to_WAN2 passthrough=no
>>
>>
>> I then have a route that matches the routing mark:
>>
>> Code: Select all
>> /ip route
>> comment=WAN2 distance=1 gateway=xxx.xxx.xx.x \
>> routing-mark=to_WAN2
>>
>>
>> After activating these rules, things starting matching the regex Layer 7
>> rules fine, CPU load was stable, but I noticed that the traffic on WAN2
>> (where most of the marked connections were going) was showing perfectly
>> equal TX and RX traffic on the interface. This maxed out the upload on
>> the connection and caused massive packet loss. Anyone have any idea why
>> the traffic would have been looping like that?
>>
>> _______________________________________________
>> Mikrotik-users mailing list
>> [email protected]
>> http://lists.wispa.org/mailman/listinfo/mikrotik-users
>
_______________________________________________
Mikrotik-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/mikrotik-users
