Default a router, go to the command line and import verbose to watch the config get pasted into the router...
If there are errors you'll see it... I HAVE noticed some of the later versions are changing command line options.... even removing some options... (Of note, NTP no-longer takes a mode=unicast, it changes mode when you enter an IP address.) -=Wayne Hancock =- SandRidge Energy, Inc. 123 Robert S. Kerr Ave Oklahoma City, OK 73102 405-429-6195 [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Roy, Jerry Sent: Friday, September 26, 2014 10:41 AM To: [email protected] Subject: [Mikrotik] Portions of config not being loaded Hi All, Need some ideas on why certain portions of a config would not be loaded. I have created a sort of "smartswitch" config template and I generate a config from it. Via Winbox I load to MT750 via the System -> Reset Configuration process where I choose my file under the "Run After Reset" then click the Reset Configuration" button. It reboots with the IP's and other bits but I find two things are missing, the default route and the ipsec policies. Any ideas? Thanks, Jerry Roy -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://mail.butchevans.com/pipermail/mikrotik/attachments/20140926/4dfa1215/attachment.html> _______________________________________________ Mikrotik mailing list [email protected] http://mail.butchevans.com/mailman/listinfo/mikrotik Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS _______________________________________________ Mikrotik mailing list [email protected] http://mail.butchevans.com/mailman/listinfo/mikrotik Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS
