I have seen this behavior in Winbox many times. Freaked me out until I
realized it was not really happening just a display glitch.

-Ty
On Aug 29, 2015 9:23 AM, "Terri Kelley" <[email protected]> wrote:

> @Mike
> I will try the CLI, didn’t think of that.
>
> @Scott
> Counters on all interfaces go to zero.
> Winbox and Webfig. Behavior is the same in both.
> Zero for a count or two, normal for a few counts then zero again. Normal
> may very and may be that way for minutes to 30 minutes. Doesn’t really
> matter what the traffic load is on the box.
> In addition, ether3 (the gateway) flaps every now and then. No rhyme,
> reason or pattern on it but I think that it is the old Media converters I
> have on it. This did this on the 750G that I had there and am replacing
> with the 1200 with an sfp.
> Pinging ether3 from the gateway side shows loss but not sure it is related
> to this. I didn’t think of pinging from the other side and will do that.
>
> @RickG
> Its a Mikrotik SFP. No on swapping it but it is new. Guess I could put a
> spare, same model in but I wouldn’t think I wouldn’t think it would be that
> interface.
>
> Terri Kelley
> Network Engineer
> 254-697-6710
> Farm to Market Broadband
>
>
>
> > On Aug 29, 2015, at 6:14 AM, Mike Hammett <[email protected]>
> wrote:
> >
> > have you verified via CLI, web interface and the remote device that this
> happens?
> >
> >
> >
> >
> > -----
> > Mike Hammett
> > Intelligent Computing Solutions
> > http://www.ics-il.com
> >
> > ----- Original Message -----
> >
> > From: "Terri Kelley" <[email protected]>
> > To: "Mikrotik discussions" <[email protected]>
> > Sent: Friday, August 28, 2015 11:32:55 AM
> > Subject: [Mikrotik] Traffic pauses on 2011UiAS
> >
> > Guys,
> >
> > I can’t figure this one out. Traffic pauses on my three eth interfaces.
> >
> > I have a 2011UiAS with one sfp module S-85DLC05D at the edge of the
> area. Another at the other end of the fiber run but we are not using the
> link yet.
> > On the edge, I’m running ospf on ether1 and 2. Default gateway out
> ether3. All our traffic is running over those three interfaces. My plan was
> to move the gateway onto the sfp module over that fiber link shutting down
> ether3.
> >
> > So testing the fiber link, when I bring up sfp1, traffic on the three
> eths will occasionally go to 0 then traffic goes again. It may do it two or
> three times in a row then not do it for awhile. If I down sfp1 then that
> doesn’t happen. If I shut down the 2011 at the other end and bring up sfp1,
> it starts again.
> >
> > I am at a loss. I have had three different versions of 6.x in it with
> current firmware. Currently on 6.30.4.
> >
> > Any ideas?
> >
> > Terri Kelley
> > Network Engineer
> > Farm to Market Broadband
> >
> >
> >
> > -------------- next part --------------
> > An HTML attachment was scrubbed...
> > URL: <
> http://mail.butchevans.com/pipermail/mikrotik/attachments/20150828/38f69941/attachment.html
> >
> > _______________________________________________
> > Mikrotik mailing list
> > [email protected]
> > http://mail.butchevans.com/mailman/listinfo/mikrotik
> >
> > Visit http://blog.butchevans.com/ for tutorials related to Mikrotik
> RouterOS
> > -------------- next part --------------
> > An HTML attachment was scrubbed...
> > URL: <
> http://mail.butchevans.com/pipermail/mikrotik/attachments/20150829/8f066abc/attachment.html
> >
> > _______________________________________________
> > Mikrotik mailing list
> > [email protected]
> > http://mail.butchevans.com/mailman/listinfo/mikrotik
> >
> > Visit http://blog.butchevans.com/ for tutorials related to Mikrotik
> RouterOS
>
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <
> http://mail.butchevans.com/pipermail/mikrotik/attachments/20150829/58298b46/attachment.html
> >
> _______________________________________________
> Mikrotik mailing list
> [email protected]
> http://mail.butchevans.com/mailman/listinfo/mikrotik
>
> Visit http://blog.butchevans.com/ for tutorials related to Mikrotik
> RouterOS
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://mail.butchevans.com/pipermail/mikrotik/attachments/20150829/e057ce91/attachment.html>
_______________________________________________
Mikrotik mailing list
[email protected]
http://mail.butchevans.com/mailman/listinfo/mikrotik

Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS

Reply via email to