Hi
My test-bed configuration is as follows:
Home subnet prefix- 2001:5c0:8d03:1::/64
Foreign subnet prefix- 2001:5c0:8d03:2::/64
Home Agent address- 2001:5c0:8d03:1::1/64
Mobile Node: Home address- 2001:5c0:8d03:1::99/64,
Care-of address- 2001:5c0:8d03:2:211:20ff:fe48:246/64
The MN has 1 wireless interface, eth0. When the MN is in the foreign
subnet in must have 2 addresses, the home address so that it can
register with the HA, and care-of address so it can communicate.
However, when I try to ping6 the HA, the MN seems to use its home
address in the foreign subnet because the HA address has the same prefix
- this obviously doesn't work. If I use "ping6 -I
2001:5c0:8d03:2:211:20ff:fe48:246 2001:5c0:8d03:1::1" it works fine,
since the MN uses the correct (care-of) address in the foreign subnet.
My problem is that when running MIPL I don't know how to specify that it
should use the care-of address (not the home address) in the foreign
subnet. Therefore, MIPL is unable to send a binding update after a
handover to the foreign network.
Is my configuration correct? If it is, have I got something else wrong?
Any solutions, comments or suggestions would be appreciated.
Thank you.
Regards
Madhush
_______________________________________________
mipl mailing list
[email protected]
http://www.mobile-ipv6.org/cgi-bin/mailman/listinfo/mipl
