Hello, Any hints on how to troubleshoot this issue? I'm looking for some kind of debug to see what is going from rib to fib in order to understand why the prefixes are not imported.
Thanks, Rimi Le 1 avril 2012 16:24, Rimi Philippe <[email protected]> a icrit : > Hello, > I'm testing OpenBSD with L3VPN, everything is working fine except from > the RT import / export side. > > I usually configure my VPN with PE Loopback:identifier, so my config > looks like this: > PE1: > rdomain 20 { > rd 1.1.1.1:20 > import-target rt 2.2.2.2:20 > export-target rt 1.1.1.1:20 > depend on mpe20 > network inet connected > } > > PE2: > rdomain 20 { > rd 2.2.2.2:20 > import-target rt 1.1.1.1:20 > export-target rt 2.2.2.2:20 > depend on mpe20 > network inet connected > } > > This kind of configuration works on Cisco devices for example, but here > > PE1: > > # bgpctl show fib table 20 > flags: * = valid, B = BGP, C = Connected, S = Static > N = BGP Nexthop reachable via this route > r = reject route, b = blackhole route > > flags prio destination gateway > *C 0 127.0.0.0/8 link#0 > *C 4 172.16.35.0/24 link#2 > *C 0 ::1/128 link#0 > > PE2: > > # bgpctl sho fib table 20 > flags: * = valid, B = BGP, C = Connected, S = Static > N = BGP Nexthop reachable via this route > r = reject route, b = blackhole route > > flags prio destination gateway > *C 0 127.0.0.0/8 link#0 > *C 4 172.16.39.0/24 link#3 > *C 0 ::1/128 link#0 > > It works fine when I set the same RD on both PE, but that's not really > what I'm looking for. > > I can't find much debug information, any hints on how to tshoot this? > > Thanks for your help, > > Remi
