Le 2013-02-20 12:17, Antoine Jacoutot a écrit :
On Wed, Feb 20, 2013 at 12:13:00PM -0500, Philippe Grégoire wrote:
Le 2013-02-20 11:56, Antoine Jacoutot a écrit :
On Wed, Feb 20, 2013 at 11:48:10AM -0500, Philippe Grégoire wrote:
Le 2013-02-20 02:44, Antoine Jacoutot a écrit :
On Tue, Feb 19, 2013 at 08:55:39PM -0500, Philippe Grégoire wrote:
Hi,
I am trying to check the possibilities with Zarafa and installed
OpenBSD 5.2 on an empty machine. Sadly, I spent the last hours
trying to figure out the cause of the following messages in
httpd's error log:
'[...] child pid $x exit signal Segmentation fault (11)'
I tried calling it with '-X' to make a ktrace but then it works(!)
Also, I checked if it might not be caused by some library so I
removed the mapi.ini file from php-5.3 folders and httpd gets fine
but Zarafa cries about php-mapi not being loaded.
In the end, I need php-mapi to use Zarafa but it crashes httpd.
o Did someone else encountered that issue and got it resolved?
o Is there some way I could ktrace httpd's child?
Any help would be appreciated, thanks.
$ sudo pkg_add -n zarafa-webaccess
<...>
Look in /usr/local/share/doc/pkg-readmes for extra documentation
Seems to me you didn't do what pkg_add(1) advised you to do.
So you cannot do better than assume I cannot read a manual?
No. I'm not a mind reader.
So, *I read pkg-readme*, configured mysql, moved php's mapi.ini
file, moved httpd's zarafa.conf file, and changed login.conf.
If I use httpd -X, I can access and "use" zarafa although it is
super slow. I read about curl and mapi conflicting but mapi is the
only extension installed.
Actually I am happy to see you (Antoine) answering that question
because I know you are closely related to that package. Hopefully
you can give better help than assuming I cannot read and poor
excuses.
It's not poor excuses. You provided *0* information; nothing about what you
did, nothing about your config....
Anyway:
http://www.openbsd.org/cgi-bin/cvsweb/ports/devel/libvmime/Makefile.diff?r1=1.13;r2=1.14;f=h
Thanks.
The diff shows the revision was prior to 5.2 but it seems it wasn't
included for it, right? My ports contain revision 0, any advice on
applying that patch?
