Looks like a crappy bios (pardon the redundancy,) try boot> boot -c
UKC > disable pcibios UKC > quit Travers On Sat, 17 Jun 2006 00:45:29 +0100 Craig Skinner <[EMAIL PROTECTED]> wrote: > Hi List, > > I've just installed 3.9 RELEASE on an i386 and got a kernel page > fault. > > Booted the box from the floppy39.fs, sliced the disk, installed some > sets & rebooted, as per normal. > > I don't use this box very often and the last release I had on it was > 3.6, which worked fine. > > Where do I go from here? 3.8? > > I piped the boot output from tip into a file: > > =07connected=0D > =FC>> OpenBSD/i386 BOOT 2.10 > =0Dbooting hd0a:/bsd: \=08|=08/=08-=08\=084966344|=08/=08-=08\=08|=08/ > =08-= =08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08- > =08\=08|=08= /=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\= =08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08= -=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|= =08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08= \=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/= =08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08= > |=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/ > =08-= =08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08- > =08\=08|=08= /=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\= =08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08= -=08\=08|=08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|= =08/=08-=08\=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08= \=08|=08/=08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/= =08-=08 > \=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08= > |=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/=08-=08\=08|=08/ > =08-= =08\=08+867848 [52+255872|=08/=08-=08\=08|=08/=08-=08\=08|=08/ > =08-=08\=08|= =08/=08-=08+237161\=08|=08/=08-=08\=08|=08/=08-=08\=08| > =08/=08-=08\=08|=08/= =08]=3D0x608d64 entry point at 0x100120 > > [ using 493460 bytes of bsd ELF symbol table ] > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights > reserved. Copyright (c) 1995-2006 OpenBSD. All rights reserved. > http://www.OpenBSD.o= rg > > OpenBSD 3.9 (GENERIC) #617: Thu Mar 2 02:26:48 MST 2006 > [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC > cpu0: Intel Pentium III ("GenuineIntel" 686-class, 128KB L2 cache) > 635 MHz cpu0: > FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE= > 36,MMX,FXSR,SSE real mem =3D 199729152 (195048K) > avail mem =3D 175271936 (171164K) > using 2463 buffers containing 10088448 bytes (9852K) of memory > mainbus0 (root) > bios0 at mainbus0: AT/286+(00) BIOS, date 01/15/99, BIOS32 rev. 0 @ > 0xfdb70 apm0 at bios0: Power Management spec V1.2 > apm0: AC on, battery charge unknown > apm0: flags 30102 dobusy 0 doidle 1 > pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 > pcibios0: PCI BIOS has 9 Interrupt Routing table entries > pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82801AA LPC" rev > 0x00) pcibios0: PCI bus #1 is the last bus > bios0: ROM list: 0xc0000/0x8000 > uvm_fault(0xd05c2f60, 0xdeeb8000, 0, 1) -> e > kernel: page fault trap, code=3D0 > Stopped at scan_smbios+0xb9: cmpb $0,0(%ebx) > ddb>=20