I have a VIA 6421 in a Dell Optiplex PPro machine where the card, BIOS, and OpenBSD's bootloader detect two identical drives just fine. When I boot in to OpenBSD, only the first drive is seen.
I've searched the archives and found http://archives.neohapsis.com/archives/openbsd/2006-08/0597.html but it doesn't seem to apply in this case as the BIOS and bootloader both detect both drives. Worthy of note is that I am booting from sd0 which the BIOS configures as the third disk. I don't imagine this is the problem and unfortunately this BIOS is too old to change that. I would be grateful for any suggestions? Output of the bootloader and a dmesg are included below. Thanks in advance. -Dan Loading... probing: pc0 com0 com1 apm mem[640k 159M a20=on] disk: fd0 hd0+ hd1+* hd2 >> OpenBSD/i386 BOOT 2.10 boot> booting hd2a:/bsd: 5839872+912272 [52+283888+268942]=0x6f78b8 entry point at 0x200120 [ using 553256 bytes of bsd ELF symbol table ] Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2006 OpenBSD. All rights reserved. http://www.OpenBSD.org OpenBSD 4.0 (GENERIC) #1104: Fri Sep 1 11:54:27 MDT 2006 [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC cpu0: Intel Pentium Pro ("GenuineIntel" 686-class, 256KB L2 cache) 180 MHz cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV real mem = 167346176 (163424K) avail mem = 145031168 (141632K) using 2068 buffers containing 8470528 bytes (8272K) of memory mainbus0 (root) bios0 at mainbus0: AT/286+(00) BIOS, date 02/11/00, BIOS32 rev. 0 @ 0xffe90 apm0 at bios0: Power Management spec V1.2 apm0: AC on, battery charge unknown apm0: flags 30102 dobusy 0 doidle 1 pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 pcibios0: PCI BIOS has 8 Interrupt Routing table entries pcibios0: PCI Interrupt Router at 000:13:0 ("Intel 82371SB ISA" rev 0x00) pcibios0: PCI bus #1 is the last bus bios0: ROM list: 0xc0000/0x8000 0xc8000/0x5000! 0xd0000/0x7000 0xd8000/0x800 cpu0 at mainbus0 pci0 at mainbus0 bus 0: configuration mode 1 (no bios) pchb0 at pci0 dev 0 function 0 "Intel 82441FX" rev 0x02 pcib0 at pci0 dev 13 function 0 "Intel 82371SB ISA" rev 0x01 pciide0 at pci0 dev 13 function 1 "Intel 82371SB IDE" rev 0x00: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility pciide0: channel 0 ignored (disabled) pciide0: channel 1 ignored (disabled) ppb0 at pci0 dev 14 function 0 "DEC 21052 PCI-PCI" rev 0x01 pci1 at ppb0 bus 1 pciide1 at pci1 dev 9 function 0 "VIA VT6421 SATA" rev 0x50: DMA pciide1: using irq 12 for native-PCI interrupt wd0 at pciide1 channel 0 drive 0: <WDC WD3200SD-01KNB0> wd0: 16-sector PIO, LBA48, 305245MB, 625142448 sectors wd0(pciide1:0:0): using PIO mode 4, Ultra-DMA mode 5 yds0 at pci1 dev 10 function 0 "Yamaha 724F" rev 0x03: irq 11 ahc0 at pci1 dev 11 function 0 "Adaptec AHA-2940U" rev 0x00: irq 11 scsibus0 at ahc0: 16 targets sd0 at scsibus0 targ 0 lun 0: <FUJITSU, MAP3367NP, 0106> SCSI3 0/direct fixed sd0: 35046MB, 48122 cyl, 2 head, 745 sec, 512 bytes/sec, 71775284 sec total vga1 at pci0 dev 16 function 0 "S3 Trio32/64" rev 0x54 wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation) wsdisplay0: screen 1-5 added (80x25, vt100 emulation) fxp0 at pci0 dev 17 function 0 "Intel 8255x" rev 0x05, i82558: irq 14, address 00:08:c7:ca:d6:f5 inphy0 at fxp0 phy 1: i82555 10/100 PHY, rev. 0 isa0 at pcib0 isadma0 at isa0 pckbc0 at isa0 port 0x60/5 pckbd0 at pckbc0 (kbd slot) pckbc0: using irq 1 for kbd slot wskbd0 at pckbd0: console keyboard, using wsdisplay0 pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 lpt0 at isa0 port 0x378/4 irq 7 npx0 at isa0 port 0xf0/16: using exception 16 pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo fdc0 at isa0 port 0x3f0/6 irq 6 drq 2 fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec biomask bf65 netmask ff65 ttymask ffe7 pctr: 686-class user-level performance counters enabled mtrr: Pentium Pro MTRR support dkcsum: wd0 matches BIOS drive 0x80 ahc0: target 0 using 16bit transfers ahc0: target 0 synchronous at 20.0MHz, offset = 0x8 dkcsum: sd0 matches BIOS drive 0x82 root on sd0a rootdev=0x400 rrootdev=0xd00 rawdev=0xd02 ac97: codec id 0x574d4c00 (Wolfson WM9701A) ac97: codec features 18 bit DAC, 18 bit ADC, No 3D Stereo audio0 at yds0 opl at yds0 not configured opl at yds0 not configured opl at yds0 not configured opl at yds0 not configured mpu at yds0 not configured mpu at yds0 not configured mpu at yds0 not configured mpu at yds0 not configured -- "Burnished gallows set with red Caress the fevered, empty mind Of man who hangs bloodied and blind To reach for wisdom, not for bread." -- Deoridhe Grimsdaughter
