Howdy Victor? I appear to be having the same problems with the same card.
Do you have any news? Thanks, Dhu On Fri, 29 May 2009 10:33:21 +0200 "Viktor Varheit" <[email protected]> wrote: > Hi, > > according to radeon(4) my graphics card is supported, but I > cannot get hardware acceleration to work. Booting with > "disable radeondrm" in UKC and then running "startx" works > fine. Doing the same with "enable radeondrm" (which is the > default in the GENERIC kernel) appears to freeze the machine. > The screen goes blank, and the monitor enters standby mode. > > Sometimes the computer shuts down after pressing the power > button, but most of the time it can only be forced off by > holding the power button. > > Trying several options in xorg.conf did not advance things. > > I booted with a serial console to see if any messages appeared > after entering "startx". This is what I got: > > radeondrm0: Setting GART location based on new memory map > radeondrm0: writeback test failed > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > ... > > The last message is repeated over and over until the machine > appears to freeze. The time it takes to get to that point > varies. > > After setting 'Option "AGPFastWrite" "on"' in xorg.conf > no messages were output at all, but that was the only > apparent difference. > > Setting "AccelMethod" to "EXA" also did not change anything. > > Using no xorg.conf at all also did not work. > > Anyway, here's my xorg.conf and dmesg. I hope someone > can give me a hint. > > Vic > > > +++ xorg.conf +++ > Section "ServerLayout" > Identifier "X.org Configured" > Screen 0 "Screen0" 0 0 > InputDevice "Mouse0" "CorePointer" > InputDevice "Keyboard0" "CoreKeyboard" > EndSection > > Section "Files" > ModulePath "/usr/X11R6/lib/modules" > FontPath "/usr/X11R6/lib/X11/fonts/misc/" > FontPath "/usr/X11R6/lib/X11/fonts/TTF/" > FontPath "/usr/X11R6/lib/X11/fonts/OTF" > FontPath "/usr/X11R6/lib/X11/fonts/Type1/" > FontPath "/usr/X11R6/lib/X11/fonts/100dpi/" > FontPath "/usr/X11R6/lib/X11/fonts/75dpi/" > EndSection > > Section "Module" > Load "dbe" > Load "dri" > Load "extmod" > Load "glx" > Load "freetype" > EndSection > > Section "InputDevice" > Identifier "Keyboard0" > Driver "kbd" > EndSection > > Section "InputDevice" > Identifier "Mouse0" > Driver "mouse" > Option "Protocol" "wsmouse" > Option "Device" "/dev/wsmouse" > Option "ZAxisMapping" "4 5 6 7" > EndSection > > Section "Monitor" > #DisplaySize 340 270 # mm > Identifier "Monitor0" > VendorName "ENC" > ModelName "L557" > HorizSync 24.0 - 80.0 > VertRefresh 50.0 - 75.0 > Option "DPMS" > EndSection > > Section "Device" > Option "AGPMode" "x4" > Option "BusType" "AGP" # [<str>] > #Option "AGPFastWrite" "on" # [<bool>] > #Option "AccelMethod" "EXA" # <str> > Option "DRI" "on" # [<bool>] > Identifier "Card0" > Driver "radeon" > VendorName "ATI" > BoardName "Radeon 9200 PRO" > BusID "PCI:1:0:0" > EndSection > > Section "Screen" > Identifier "Screen0" > Device "Card0" > Monitor "Monitor0" > SubSection "Display" > Viewport 0 0 > Depth 1 > EndSubSection > SubSection "Display" > Viewport 0 0 > Depth 4 > EndSubSection > SubSection "Display" > Viewport 0 0 > Depth 8 > EndSubSection > SubSection "Display" > Viewport 0 0 > Depth 15 > EndSubSection > SubSection "Display" > Viewport 0 0 > Depth 16 > EndSubSection > SubSection "Display" > Viewport 0 0 > Depth 24 > EndSubSection > EndSection > > +++ dmesg +++ > OpenBSD 4.5-stable (GENERIC) #0: Sun May 3 11:29:20 CEST 2009 > [email protected]:/usr/src/sys/arch/i386/compile/GENERIC > cpu0: AMD Athlon(tm) XP 2000+ ("AuthenticAMD" 686-class, 256KB L2 cache) 1.68 > GHz > cpu0: > FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE > real mem = 804810752 (767MB) > avail mem = 769404928 (733MB) > mainbus0 at root > bios0 at mainbus0: AT/286+ BIOS, date 10/18/06, BIOS32 rev. 0 @ 0xfdb10, > SMBIOS rev. 2.3 @ 0xf0630 (21 entries) > bios0: vendor American Megatrends Inc. version "P2.80" date 10/18/2006 > bios0: American Megatrends Inc. K7S41GX > acpi0 at bios0: rev 0 > acpi0: tables DSDT FACP APIC > acpi0: wakeup devices PS2M(S4) PS2K(S4) UAR1(S4) USB1(S4) USB2(S4) EHCI(S4) > LAN_(S4) MDM_(S4) AUD_(S4) PCI0(S4) > acpitimer0 at acpi0: 3579545 Hz, 24 bits > acpimadt0 at acpi0 addr 0xfee00000: PC-AT compat > cpu0 at mainbus0: apid 0 (boot processor) > cpu0: apic clock running at 268MHz > ioapic0 at mainbus0: apid 2 pa 0xfec00000, version 11, 24 pins > acpiprt0 at acpi0: bus 0 (PCI0) > acpicpu0 at acpi0 > acpibtn0 at acpi0: PWRB > bios0: ROM list: 0xc0000/0xd000 0xcd000/0xa000 > pci0 at mainbus0 bus 0: configuration mode 1 (bios) > pchb0 at pci0 dev 0 function 0 "SiS 741 PCI" rev 0x03 > sisagp0 at pchb0 > agp0 at sisagp0: aperture at 0xd0000000, size 0x8000000 > ppb0 at pci0 dev 1 function 0 "SiS 648FX AGP" rev 0x00 > pci1 at ppb0 bus 1 > vga1 at pci1 dev 0 function 0 "ATI Radeon 9200 PRO" rev 0x01 > wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation) > wsdisplay0: screen 1-5 added (80x25, vt100 emulation) > radeondrm0 at vga1: apic 2 int 16 (irq 11) > drm0 at radeondrm0 > pcib0 at pci0 dev 2 function 0 "SiS 85C503 System" rev 0x25 > pciide0 at pci0 dev 2 function 5 "SiS 5513 EIDE" rev 0x00: 741: DMA, channel > 0 wired to compatibility, channel 1 wired to compatibility > wd0 at pciide0 channel 0 drive 0: <IBM-DTTA-350840> > wd0: 16-sector PIO, LBA, 8063MB, 16514064 sectors > wd1 at pciide0 channel 0 drive 1: <WDC WD800JB-00ETA0> > wd1: 16-sector PIO, LBA48, 76319MB, 156301488 sectors > wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 > wd1(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 5 > wd2 at pciide0 channel 1 drive 0: <WDC WD1600JB-22GVC0> > wd2: 16-sector PIO, LBA48, 152627MB, 312581808 sectors > atapiscsi0 at pciide0 channel 1 drive 1 > scsibus0 at atapiscsi0: 2 targets > cd0 at scsibus0 targ 0 lun 0: <HL-DT-ST, DVD-RAM GSA-H55L, 1.03> ATAPI > 5/cdrom removable > wd2(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 5 > cd0(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 4 > ohci0 at pci0 dev 3 function 0 "SiS 5597/5598 USB" rev 0x0f: apic 2 int 20 > (irq 5), version 1.0, legacy support > ohci1 at pci0 dev 3 function 1 "SiS 5597/5598 USB" rev 0x0f: apic 2 int 21 > (irq 3), version 1.0, legacy support > ehci0 at pci0 dev 3 function 2 "SiS 7002 USB" rev 0x00: apic 2 int 23 (irq 10) > usb0 at ehci0: USB revision 2.0 > uhub0 at usb0 "SiS EHCI root hub" rev 2.00/1.00 addr 1 > sis0 at pci0 dev 4 function 0 "SiS 900 10/100BaseTX" rev 0x90: apic 2 int 19 > (irq 5), address 00:19:66:65:10:93 > rlphy0 at sis0 phy 1: RTL8201L 10/100 PHY, rev. 1 > trm0 at pci0 dev 9 function 0 "Tekram DC-3x5U" rev 0x01: apic 2 int 17 (irq 5) > scsibus1 at trm0: 8 targets, initiator 7 > envy0 at pci0 dev 10 function 0 "IC Ensemble Envy24 I/O Ctrlr" rev 0x02: apic > 2 int 18 (irq 10) > audio0 at envy0 > isa0 at pcib0 > isadma0 at isa0 > com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo > pckbc0 at isa0 port 0x60/5 > pckbd0 at pckbc0 (kbd slot) > pckbc0: using irq 1 for kbd slot > wskbd0 at pckbd0: console keyboard, using wsdisplay0 > pms0 at pckbc0 (aux slot) > pckbc0: using irq 12 for aux slot > wsmouse0 at pms0 mux 0 > pcppi0 at isa0 port 0x61 > midi0 at pcppi0: <PC speaker> > spkr0 at pcppi0 > lpt0 at isa0 port 0x378/4 irq 7 > wbsio0 at isa0 port 0x2e/2: W83697HF rev 0x12 > lm1 at wbsio0 port 0x290/8: W83697HF > npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 > fdc0 at isa0 port 0x3f0/6 irq 6 drq 2 > fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec > usb1 at ohci0: USB revision 1.0 > uhub1 at usb1 "SiS OHCI root hub" rev 1.00/1.00 addr 1 > usb2 at ohci1: USB revision 1.0 > uhub2 at usb2 "SiS OHCI root hub" rev 1.00/1.00 addr 1 > mtrr: Pentium Pro MTRR support > softraid0 at root > root on wd1a swap on wd1b dump on wd1b > radeondrm0: Setting GART location based on new memory map > radeondrm0: writeback test failed > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > radeondrm0: wait idle failed status : 0x80010140 0x00000000 > ... > > -- > Nur bis 31.05.: GMX FreeDSL Komplettanschluss mit DSL 6.000 Flatrate und > Telefonanschluss nur 17,95 Euro/mtl.!* http://portal.gmx.net/de/go/dsl02
