Christian Richter ha scritto:
Massimo De Nadal wrote:
Hi,
I'm triyng to use a junghanns quadbri 2.0 (the new one with hw
watchdog) with chan_misdn.
"misdn-init scan" seems to find the card and "misdn-init start" loads
the hfcmulti module but asterisk fails to load chan_misdn.so.
Does anybody know if hfcmulti modules works correctly with quadbri
2.0 boards ?
Thanks.
what's the failure message?
Thank you for your answer.
This is what happens:
misdn-init scan:
[OK] found the following devices:
card=1,0x4
[ii] run "/usr/sbin/misdn-init config" to store this information to
/etc/misdn-init.conf
misdn-init config::
[OK] /etc/misdn-init.conf created. It's now safe to run
"/usr/sbin/misdn-init start"
[ii] make your ports (1-4) available in asterisk by editing
"/etc/asterisk/misdn.conf"
misdn-init start:
-----------------------------------------
Loading module(s) for your misdn-cards:
-----------------------------------------
modprobe --ignore-install hfcmulti type=0x4 protocol=0x2,0x2,0x2,0x2
layermask=0xf,0xf,0xf,0xf poll=128 debug=0
modprobe mISDN_dsp debug=0x0 options=0 dtmftreshold=100
asterisk -c
.....
Dec 16 09:26:42 ERROR[1970]: chan_misdn.c:4120 load_module: Unable to
initialize mISDN
.....
All seems to work fine before starting asterisk.
Using 2 zaphfc cards the system works really fine (btw thank you VERY
much for chan_misdn, il really changes my life).
To try the quadbri card I've only changed the ports list in misdn.conf.
Any ideas ?
_______________________________________________
Misdn-asterisk mailing list
[email protected]
http://lists.beronet.com/cgi-bin/mailman/listinfo/misdn-asterisk
