Okay, well it looks like my rear wiper is not working. I guess its one of those things that you don't notice until its broke. Anyway, I narrowed it down a little bit:
- The washer still pumps fluid out the back when the stalk is pushed back. I am nearly positive that my wiper switch is okay judging by this. - I measured the voltage coming off of the two hot wires at the motor. Both were around 2 volts when the switch was turned on. - The intermitent relay. I have a good reason to believe this is my problem. Anyone else have a similar problem with their rear wiper? Did it end up being the relay? FYI- This weekend my passenger side wiper arm began to strip on the splines. Of course this happens only when its raining, and you are not close to home. Here's a quick fix: Take a piece of napkin (tissue is too thin), and wet it slightly. Then take the small piece (half inch by half inch or so) and put it on the spline. Put the arm back on, over the piece of napkin. If you tighten the arm back down in the proper position, it should be fine and will hold quite tight. Denis G. __________________________________________________ Do You Yahoo!? Get personalized email addresses from Yahoo! Mail - only $35 a year! http://personal.mail.yahoo.com/ _____________ List Sponsor: http://www.netsville.com To remove yourself from this list, send mail to [email protected] with 'unsubscribe a2_16v' in the body of your message See us on the web at http://www.a2-16v.com Visit the 16V Homepage at http://www.gti16v.org
