Next question..... On the oil filter flange does it matter where each oil pressure sender is located?
On the side of the head which sender (left or right) is used for the Coolant temp gauge? What colour is the sender (white or black)? Thanks, Mark Reda. ----- Original Message ----- From: "Galen Bergthold" <[email protected]> To: <[email protected]> Sent: Friday, October 22, 2004 10:19 PM Subject: Re: [a2-16v-list] A few Wiring Questions > From the Bentley ch 3 p 41: > Dynamic Oil Pressure Warning System > "On 16-valve engines, both switches are located on the filter flange." > > > >From: "Mark Reda" <[email protected]> > >To: "Galen Bergthold" <[email protected]>,"a2list" > ><[email protected]> > >Subject: Re: [a2-16v-list] A few Wiring Questions > >Date: Fri, 22 Oct 2004 21:24:44 -0400 > > > >Anyone correct me if I'm wrong.... > > > >1. Engine oil temp sensor G/BK > >is the oil temp sensor is on the oil filter housing? > >my green/black wire is on the back of the head. > > > >2. Engine oil press sw 0.3 bar BL/BK > >my blue/black is located near the oil filter housing., I thought the low > >pressure switch was on the back of the head. > > > >3. Engine oil press sw 1.8 bar Y > >my Yellow is located on the oil filter housing. > >The yellow wire hooks up to the black oil press. switch? > > > >4. Coolant temp send unit Y/R > >This one is right! > > > > > > > >----- Original Message ----- > >From: "Galen Bergthold" <[email protected]> > >To: <[email protected]> > >Sent: Friday, October 22, 2004 8:12 PM > >Subject: RE: [a2-16v-list] A few Wiring Questions > > > > > > > From the Bentley, p.226 fora 91-92 Jetta GLI, German production: > > > Engine oil temp sensor G/BK > > > Engine oil press sw 0.3 bar BL/BK > > > Engine oil press sw 1.8 bar Y > > > Coolant temp send unit Y/R > > > > > > > > > >From: "Mark Reda" <[email protected]> > > > >To: "a2list" <[email protected]> > > > >Subject: [a2-16v-list] A few Wiring Questions > > > >Date: Fri, 22 Oct 2004 18:08:05 -0400 > > > > > > > >I'm putting the head back on my 16V and I'm having a hard time figuring > >out > > > >which wires connect to a few senders on a 9A with CIS-E Motronic (91 > > > >GTX)..... > > > > > > > >Which colour wires are for the.... > > > >1. Black oil pressure sender on the oil filter housing > > > >2. MFA temp sender on the oil filter housing > > > >3. Coolant gauge temp sender on the side of the block under the > >distributor > > > >4. Blue oil pressure sender on back of the head > > > > > > > >Thanks, > > > >Mark. > > > >_______________________________________________ > > > >a2-16v-list mailing list > > > >[email protected] > > > >http://mail.a2-16v.com/mailman/listinfo/a2-16v-list > > > >For list archives, see listinfo link above. > > > > > > > > > > > > > >
