Hey, > > Yes, it's like that, I'm calling --simple-disconnect and -d for the > modem before enabling the modem again and trying to register via > --3gpp-register-in-operator=xxx, then I check if I'm connected to the > correct operator by comparing the operator in mmcli -m 0 to the operator > I tried to connect to(can I verify like that that I'm connected to the > correct operator?) > > If that is successfull, I use --simple-connect(do I even have to do that?) >
That sequence looks quite well to me. > So you see, I'm not doing a 3gpp scan explicitly, I'm just (simple) > disconnecting, disabling the modem, enabling again, trying to (3gpp) > register in operator, if successful I try to (simple) connect which is > always successful if register in operator was successful before > > Do you have any advice for me what I could do right now? > I believe you can try to just call --simple-connect with the additional "operator-id=XXXX" parameter; then just --simple-disconnect, and retry the --simple-connect with the next operator id and so on. -- Aleksander https://aleksander.es _______________________________________________ ModemManager-devel mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/modemmanager-devel
