Hi all,
I want to calculate the concentration factor for the 2D structure which is
mentioned in page 71 of the second edition of " Photonic Crystals Molding the
Flow of Light". But for TE mode, MPB gives 9% for the 1st band and 23% for the
second band which should be vice versa according to the book! Actually, this
problem was reported once before in this address:
http://www.mail-archive.com/[email protected]/msg00480.html, but
there is no reply for this!!
Would you please tell me the point that I did not notice? Used commands for MPB
is mentioned below.
Thank you very much.
Arash
-----------------2D PC square lattice, R=0.2a Eps=8.9-------------------
(set! num-bands 3)
(set! k-points (list (vector3 0 0 0) (vector3 0.5 0 0) ))
(set! k-points (interpolate 16 k-points))
(set! geometry (list (make cylinder (center 0 0 0) (radius 0.2) (height
infinity) (material (make dielectric (epsilon 8.9))))))
(set! geometry-lattice (make lattice (size 1 1 no-size)))
(set! resolution 128)
(run-te
(output-dpwr-in-objects output-dpwr 0 (make cylinder (center 0 0 0)
(radius 0.2) (height infinity)
(material (make dielectric (epsilon 8.9)))))
)
_______________________________________________
mpb-discuss mailing list
[email protected]
http://ab-initio.mit.edu/cgi-bin/mailman/listinfo/mpb-discuss
