Hi Bill, On Thu, May 13, 2010 at 8:31 AM, Bill Hart <[email protected]> wrote:
<SNIP> > The fulvia build failure again looks like config.h is corrupted, which > suggests the build wasn't clean. FWIW this is what I get when uncompressing the MPIR tarball I wrapped up on sage.math and then scp to Skynet: [mv...@fulvia mpir]$ ls mpir-trunk.tar.bz2 tune.sh [mv...@fulvia mpir]$ bunzip2 mpir-trunk.tar.bz2 [mv...@fulvia mpir]$ ls mpir-trunk.tar tune.sh [mv...@fulvia mpir]$ tar -xf mpir-trunk.tar tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file tar: ././@LongLink: typeflag 'L' not recognized, converting to regular file -- Regards Minh Van Nguyen -- You received this message because you are subscribed to the Google Groups "mpir-devel" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/mpir-devel?hl=en.
