Today you sent me mail regarding [rrd-developers] Counter limitation: *> Dear Developers, *> *> I have adopted a RRD tool with mrtg. *> But, i notice that i can't see actual utilization *> when the utilization of link is over about 120Mbps. *> *> We use the Cisco router with high bandwidth link, *> 155Mbps ATM, FastEtherChannel, etc. *> *> In my opinion, the problems are our router which uses *> the 32bit counter. *> Therefore, i have modified some code of mrtg and *> decreases the interval to 1 minute. *> It' looks fine. However, this is not the solutions because of *> 32bit counter. *> *> Question *> i) How to use a MRTG or RRD when physical utilization is over 120Mbps ? *> How to see the utilization ?
exactly the way you did it ... *> ii) Is it possible to count the counter wrap in SNMP world ? *> If so, please let me know. not to my knowledge *> iii) Finally, how we can see the physical utilization as though the link *> is over 200Mbps or 1Gbps ? you realy need to get into 64bit counters ... some devices support this now ... cheers tobi *> *> Thanks. *> *> Best Regards, *> Austin Oh (Myoungsub Oh in korean) *> National Computerization Agency. *> *> -- *> * To unsubscribe from the rrd-developers mailing list, send a message with the *> subject: unsubscribe to [EMAIL PROTECTED] *> *> -- ______ __ _ /_ __/_ / / (_) Oetiker, Timelord & SysMgr @ EE-Dept ETH-Zurich / // _ \/ _ \/ / TEL: +41(0)1-6325286 FAX:...1517 ICQ: 10419518 /_/ \.__/_.__/_/ [EMAIL PROTECTED] http://ee-staff.ethz.ch/~oetiker -- * To unsubscribe from the rrd-developers mailing list, send a message with the subject: unsubscribe to [EMAIL PROTECTED]
