The default bandwidth setting for a tunnel interface is 9k (Cisco platform). You can either add a bandwidth statement on your tunnel interface (be aware of the routing metric impact) or just change your config file.
Hope this helps
Greg
"AS, Raj Kumar"
<[EMAIL PROTECTED] To: [EMAIL PROTECTED]
on.com> cc:
Sent by: Subject: [mrtg] Util graph for
a tunnel interface.--help needed.
[EMAIL PROTECTED]
ee.ethz.ch
01/28/2003 11:24
PM
Hi Group,
I have router with a tunnel interface to another location. I was told that
the BW of the tunnel is 128K. I want to plot the util graph using MRTG.
When
I run MRTG and create the config file I find the following info below..
System: XXXXX- in
Maintainer:
Description: Tunnel10 Tunnel to XXXXX-R1
ifType: Other (1)
ifName: Tu10
Max Speed: 1125.0 Bytes/s
Ip: x.x.x.x ()
Why is that the Max speed is only 9Kb (1125Bytes).
Can somebody help. Thanks for the time..
Best Regards,
Raj.
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
