Does that mean the maximum BW I can have is 9K? If I change the BW to 128K in the router can I use upto 128K.
I think its better to change that on the mrtg config file. suggestions?? Best Regards, Raj. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Wednesday, January 29, 2003 1:51 PM To: AS, Raj Kumar Cc: [EMAIL PROTECTED]; [EMAIL PROTECTED] Subject: Re: [mrtg] Util graph for a tunnel interface.--help needed. The default bandwidth setting for a tunnel interface is 9k (Cisco platform). You can either add a bandwidth statement on your tunnel interface (be aware of the routing metric impact) or just change your config file. Hope this helps Greg "AS, Raj Kumar" <[EMAIL PROTECTED] To: [EMAIL PROTECTED] on.com> cc: Sent by: Subject: [mrtg] Util graph for a tunnel interface.--help needed. [EMAIL PROTECTED] ee.ethz.ch 01/28/2003 11:24 PM Hi Group, I have router with a tunnel interface to another location. I was told that the BW of the tunnel is 128K. I want to plot the util graph using MRTG. When I run MRTG and create the config file I find the following info below.. System: XXXXX- in Maintainer: Description: Tunnel10 Tunnel to XXXXX-R1 ifType: Other (1) ifName: Tu10 Max Speed: 1125.0 Bytes/s Ip: x.x.x.x () Why is that the Max speed is only 9Kb (1125Bytes). Can somebody help. Thanks for the time.. Best Regards, Raj. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
