Daniel,
Thank you for your help! I originally planned to use subint's
but apparantly you cant create a subint on a LAN interface on any cisco
router under a 2620. Actually, let me correct that, I can create a
subint but can not assign it an IP address.
Would it not be possible to use the following example:
Target[ezwf]: /1.2.3.4:[EMAIL PROTECTED]
For each individual IP aliases to eth0? Thanks again!
Peter
On Thu, Mar 06, 2003 at 06:00:28PM -0600, McDonald, Dan wrote:
>
> Three options:
> 1. use QOS (e.g. CAR) and monitor the QOS rules
> 2. use netflow instead of mrtg
> 3. Re-engineer your network with vlans and create sub-interfaces, whilst
> upgrading to 12.2T for support of Dot1q subinterfaces under snmp...
>
>
> Daniel J McDonald, CCIE #2495, CNX
> Lan/Wan Integrator
> Austin Energy
> 1.512.322.6739
> [EMAIL PROTECTED]
>
>
> -----Original Message-----
> From: Peter Sanchez [mailto:[EMAIL PROTECTED]
> Sent: Thursday, March 06, 2003 10:59 AM
> To: [EMAIL PROTECTED]
> Subject: [mrtg] Network Usage based on IP??
>
>
>
> Hi all. Im in a bit of a jam. I need to know if its possible to monitor
> network usage based on the IP address and not interface. Reason being,
> ill have 5-6 different networks all on the same interface and I need to
> monitor each individual network. The router is a cisco 806 (Full IOS,
> 12.2(4)). Thanks for any help you can give!
>
> Peter
>
> --
> Unsubscribe mailto:[EMAIL PROTECTED]
> Archive http://www.ee.ethz.ch/~slist/mrtg
> FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
> WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
>
> --
> Unsubscribe mailto:[EMAIL PROTECTED]
> Archive http://www.ee.ethz.ch/~slist/mrtg
> FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
> WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
