Is it possible to make the 64-bit counter separate from SNMPv2? As I discussed in some previous posts, I have some Nortel equipment (OM3500) which only accepts SNMPv1, but does populate the 64-bit counters. I realize this is pretty non-standard, but I did finally get this working by specifying the 64-bit OIDs directly in the config. It would be nice to be able to tell MRTG to use the 64-bit counters even though SNMPv1 is being used. OTOH, I recognize that this case is probably one of the few instances this would be useful, and so this cannot be very high on the priority list.
Russ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Tobias Oetiker Sent: Thursday, March 29, 2007 8:42 AM To: MrPaul Cc: [email protected] Subject: Re: [mrtg] MRTG draws wrong when the traffic arrive 100 ~110 Mbit... Hi MrPaul, cfgmaker will check for 64bit snmpv2 counters as soon as you tell it to use snmpv2 ... it will fall back to 32bit counters automagically if it does not find them. cheers tobi -- Tobi Oetiker, OETIKER+PARTNER AG, Aarweg 15 CH-4600 Olten http://it.oetiker.ch [EMAIL PROTECTED] ++41 62 213 9902 _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg The information contained in this e-mail and any accompanying documents is intended for the sole use of the recipient to whom it is addressed, and may contain information that is privileged, confidential, and prohibited from disclosure under applicable law. If you are not the intended recipient, or authorized to receive this on behalf of the recipient, you are hereby notified that any review, use, disclosure, copying, or distribution is prohibited. If you are not the intended recipient(s), please contact the sender by e-mail and destroy all copies of the original message. Thank you. _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
