Hi Chris,
Yes there is an existing ticket about this (
https://ms4w.com/trac/ticket/425 ), however I will update the
documentation now on ms4w.com so that others can see the correct steps,
until the next release.
thanks for using MS4W,
-jeff
--
Jeff McKenna
GatewayGeo: Developers of MS4W, & offering MapServer Consulting/Dev
co-founder of FOSS4G
http://gatewaygeo.com/
On 2024-10-30 12:51 p.m., Christopher Hughes via MS4W-Users wrote:
Hi all,
I'm working updating to MS4W 5.0 and I ran into an issue enabling FCGI.
The map doesn't load, and when I try to view any of the individual
mapserv requests, I get an 'msLoadConfig(): Unable to access file.' error.
After a bit of digging, it looks like the issue is caused by the (newly
required) ms4w.conf file not being found when fcgi is being used. I
added a line the fcgi IfModule section setting the mapserver config file
location ("FcgidInitialEnv MAPSERVER_CONFIG_FILE "/ms4w/ms4w.conf") and
things seemed to work as expected.
I'm mainly mentioning this because I didn't see this in the ms4w fcgi
documentation so it may be useful to add it as an example in the
<IfModule> block, and I also wanted to make sure there weren't any other
fcgi directives that now needed to be set.
Chris
--
Chris Hughes
GIS Analyst
Lincoln County GIS Department
880 NE 7th St. l Newport, OR 97365
Tel: (541) 574 1283
_______________________________________________
MS4W-Users mailing list
[email protected]
https://lists.ms4w.com/mailman/listinfo/ms4w-users
_______________________________________________
MS4W-Users mailing list
[email protected]
https://lists.ms4w.com/mailman/listinfo/ms4w-users
