David, Thanks for the response! I had not used the dbcreatewizard in so long I was not even sure it was still there :-). Thanks again
Albert ________________________________ From: David Biot <[email protected]> To: "[email protected]" <[email protected]> Sent: Monday, August 5, 2013 4:09 AM Subject: RE: [msmom] SCOM DB Dear Albert, You can use 2 ways to create the database: · Using the normal SCOM setup wizard · Using dbcreatewizard Kevin wrote a blog about both possibilities: http://blogs.technet.com/b/kevinholman/archive/2008/05/03/dbcreatewizard-or-just-run-good-old-setupom-exe-which-should-i-use-to-install-the-database-component-of-opsmgr.aspx Whenever I’m with a customer where the SQL team asks to configure the database in front, I tend to propose to use the dbcreatewizard method. It is a low impact wizard that executes rather fast. It only creates the database with some security settings, tables and basic information in it. You can easily create a procedure in a dev environment that can be executed by another team (e.g. the SQL team) in other environments. Many regards, David Biot Technical Project Leader [email protected] Direct +32 2 801 41 52 This e-mail message and any attachment are intended for the sole use of the recipient(s) named above and may contain information which is confidential and/or protected by intellectual property rights. Any use of the information contained herein (including, but not limited to, total or partial reproduction, communication or distribution in any form) by other persons than the designated recipient(s) is prohibited. If you have received this e-mail in error, please notify the sender either by telephone (+32 2 801 55 55) or by e-mail and delete the material from any computer. Please note that neither RealDolmen nor the sender accept any responsibility for viruses and it is your responsibility to scan or otherwise check this email and any attachments. RealDolmen is nor responsible for the correct and complete transfer of the contents of the sent e-mail, neither for the receipt on due time. From:[email protected] [mailto:[email protected]] On Behalf Of Albert Kirkpatrick Sent: donderdag 25 juli 2013 19:15 To: [email protected] Subject: [msmom] SCOM DB Hi All, is there a way to use an existing Database for a management group? My SQL team wants to configure somethings up front for the database architecture,but it seems the setup process only wants to allow the creation of a new DB from the setup wizard. Thanks Al
