I do the following:
1. connent NT to W2K through LAN, Damewware works ok
LAN
NT-----------W2K
2. Then I disconnect NT from LAN and use a crossover cable to connect
W2K and NT, dameware stop work. they r in the same subnet
Best regards,
Tom mailto:[EMAIL PROTECTED]
Monday, July 16, 2001="", you wrote:
PC> Tom,
PC> Dameware should allow you to connect by IP or machine name. Assuming no IP
PC> problems, when I have received the failed message before, it usually means
PC> the Dameware service is not started and I/you do not have the privledges to
PC> start it on that machine. Check the stupid things like logging in from a
PC> different domain userid than is expected.
PC> When I install and run Dameware for the first time on a server, I always
PC> configure it to Manually start the service, and to stop the service on
PC> disconnect to conserve resources incidentally.
PC> Are you able to connect to your Named Internet with Dameware?
PC> Do you have connectivity to the machine on both NICS<ping>?
PC> Are you logging in with the right credentials <it is selectable in the
config>>?
PC> Patrick
PC> -------------
PC> Hello Patrick,
PC> thx, another Q:
PC> I now have two NIC cards on my computer:
PC> 1. connected to Internet (Named Internet)
PC> 2. connected to NT (Named Private)
PC> now I want to use Dameware to connect NT, failed, is there any setting
PC> I ignored?
PC> Best regards,
PC> Tom mailto:[EMAIL PROTECTED]
PC> ------
PC> You are subscribed as [EMAIL PROTECTED]
PC> Archives: http://www.swynk.com/sitesearch/search.asp
PC> To unsubscribe send a blank email to %%email.unsub%%
------
You are subscribed as [email protected]
Archives: http://www.swynk.com/sitesearch/search.asp
To unsubscribe send a blank email to [EMAIL PROTECTED]
