Hello,
>> Yes, I know the way Drive Select works. The trouble was that there are no
>> markings on the drive PCB.
If you can't find markings or jumper, remove the 34-pins connector at the
side of the drive. Make sure you switch wire of pin 10 with the wire of pin
12... (I always separate wires 1 to 9 from 10 to 34 and then wire 10-12 from
13 to 34... You then get three pieces of flatcable that can be put easily
back in the connector! Don't forget to siwtch 10-12...).
For people who understand Dutch, we made a little booklet with all problems
you can get when you drives goes bananas! Ofcourse we tell you how to solve
them!
Maybe I have time, I translate it into English and put it on the net!?
--[ MARI ]--
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
