>Some year ago, I 've bought an IDE-interface from Sunrise.
Nevertheless it
>doesn't seem to work on my MSX2. I use a Seagate ST3290A
harddisk and no
>cdrom.
Is the Harddisk ATA compliant?
Did you program it with the cartridge in slot 2 as the "readme"
discribes?
Do you use extra cartridges in your computer? -> pull all of them
out of your computer, except may be MSX-DOS 2.
>I think that the mainproblem is the cable/and/or the (too
fast/slow) in/out
>datatransfer because when the interface boots, the harddisk's
drivename is
>displayed incorrect. Also when I try to save the partition table
with
>FDISKIDE and try to read the table, the partitioninfo is gone...
This problem sounds familiar. It occured when I used a Megascsi
with it. Also the interface doesn't always like memorymappers.
>Perhaps some of you folks knows the answer.
>
>By the way, are there in fact IDE-interfaces working on msx2???
>
>Keep MSX'ing!!!
>CU at Tilburg!
You got thaty right!
Greetings
Maico Arts
[EMAIL PROTECTED]
>
>****
>MSX Mailinglist. To unsubscribe, send an email to
[EMAIL PROTECTED] and put
>in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]"
(without the
>quotes :-) Problems? contact [EMAIL PROTECTED]
(www.stack.nl/~wiebe/mailinglist/)
>****
>
>
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
