> >When I use SET SCREEN command, my computer (tR A1ST) forgets, what was the
> >target-ID, what it needed for boot. Sometimes it even makes it very
> >difficult to change because, when I try to go to the SETUP menu, it will
> >hang after "Wait..."-message.
>
> What I do is lat the computer go to basic and then set the right host and
> target id with the basic-commands. Then reboot your computyer and it won�t
> be any problem to go into your novaxis setup.
> BTW: if you don�t know the basic commands: type CALL INFO
Well, this was a good tip, thanx !
Actually, I know these commands, but I have newer thought this kind of
possibility, when my computer has been jammed. Atleast this is mutch
better way, than using OUT-commands. I usually do things by using too hard
way. :-)
Greetings:
,_____.
_=_=_=_=!_MSX_!=_=_=_=_=_=_=_=_,
! A1ST ~--- - I ( o o o o o o )i
/--------------------------------`,
/ .::::::::::::::::::::::;::; ::::.,
/ :::.:.:.:::____________:::::!. -=- `,
~======================================
NYYRIKKI : [EMAIL PROTECTED]
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
