>This reminded me about my SCSI-interface...
>I have a (small) probblem :
>
>When I use SET SCREEN command, my computer (tR A1ST) forgets, what was the
>target-ID, what it needed for boot. Sometimes it even makes it very
>difficult to change because, when I try to go to the SETUP menu, it will
>hang after "Wait..."-message.
What I do is lat the computer go to basic and then set the right host and
target id with the basic-commands. Then reboot your computyer and it won�t
be any problem to go into your novaxis setup.
BTW: if you don�t know the basic commands: type CALL INFO
greetings from the Netherlands
Maico Arts
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
