Hello,
> It really doesn't matter whether you connect 33 to 34 (ground the
> busy signal) at the side of the drive or on the computer motherboard.
> It's electronically the same! My advice would be the total opposite:
> do the soldering on the diskdrive. Don't risk destroying the
> motherboard.
You're right, but...
There's a reason why I do this, because I make the connection in the CABLE
not on the motherbord. Simply cutting both wires (pin 33 and 34) and open
the connector. Remove wire of pin 34 and make a little loop with the piece
of wire that is still connected to pin 33! Close the connector and put it
back in place!
This can be done even by people who do not know which end of the
soldering-iron is HOT! And there are a lot of them :)
--[ MARI ]--
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
