Hi,
Thanks, you guys are great... I should have known that I had to look
there...
>> I'll give the SCC option a try then. If it works I'll make the
modification.
>>
>> If I would put a resistor on PIN49, how would I need to connect it ? Can
I
>> simply put 'any' resistor on 'pin 49' of the 'connector' ? Do I have to
make
>> the 'resistor' the only way the signal can pass by 'cutting' pin 49 in
half
>> or can I simply solder it on it and it'll work (sorry my electronics
>> knowledge is practically non existant) ?
>>
>>
>> >No... You have to use a resistor on PIN49.. But try an SCC, it works!
>On The ULtimate MSX FAQ is a question (+answer of course!) dedicated to
this
>problem in the Misc FAQ section. Check it out at http://www.faq.msxnet.org
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED]
and put "unsubscribe msx [EMAIL PROTECTED]" (without the quotes) in
the body (not the subject) of the message.
Problems? contact [EMAIL PROTECTED]
More information on MSX can be found in the following places:
The MSX faq: http://www.faq.msxnet.org/
The MSX newsgroup: comp.sys.msx
The MSX IRC channel: #MSX on Undernet
****
