At 12:48 9-7-00 +0200, you wrote:
> > > >MemMan sucks.
> > > >It loads in an awful way (exiting to Basic).
> >
> > AFAIK, there is the ONLY way in which a TSR can be loaded. It is due to
> > an incomplete design of MSX-DOS (makers did not though on page 3 memory
> > reservation...) However it is posible to avoid the BASIC exit messages
> > and the "_SYSTEM" print in the screen. I explain it in SD MESXES#13. 8-)
>
>Could you explain the exact problem?
I think it's lazy to go to Basic to intialize, from Basic you need to
continue doing something (bult-in use of keyboardbuffer) when MemMan is
loaded. Setting up the system for MemMan is much work and slows down the
boot-up process. Besides, you always see the message MemMan has been
installed. It should help if you could switch off the printing part. Allas,
you cannot.
>Because even when it happens in a non-visible way, it's still not a nice
>solution and very slow.
The problem is, you always see the welcome message of MemMan. You can't
switch it off.
GreeTz, BiFi
Visit my Home Page at www.bifi.msxnet.org
mail me at: [EMAIL PROTECTED]
FTP: ftp.bifi.msxnet.org
ICQ #36126979
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED]
and put "unsubscribe msx [EMAIL PROTECTED]" (without the quotes) in
the body (not the subject) of the message.
Problems? contact [EMAIL PROTECTED]
More information on MSX can be found in the following places:
The MSX faq: http://www.faq.msxnet.org/
The MSX newsgroup: comp.sys.msx
The MSX IRC channel: #MSX on Undernet
****
