> Alex Wulms wrote:
> > However, on 8-bits and on 16-bits systems, octals are not so convenient
to
> > use, for obvious reasons.
>
> If you are reading sectors and you see each byte as octal you can read
> Z80 ml much more easilly.
> For example with 101 then you can see directly that it means "ld a,b"
> The entire Z80 is verry octal based in its opcode structure.

IMHO it's very binary based. There is definately a logic in it, but it's not
octal. Octal can be useful for some byte-register instructions; there are 8
registers so the registernr. in 8-bit instructions is represented by three
digits. And if this 'accidentally' starts at an 3-bit 'offset' (bit 2, bit
5), then it can look very logical. But at the other hand, most (if not all)
16-bit instructions use a 2-bit register descriptor (BC, DE, HL and SP), and
those don't appear to be logic at all in octal notation.

I think it's quite coincidental (with a higher chance because of the
similarities with the binary system).


~Grauw


--
>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<
 email me: [EMAIL PROTECTED] or ICQ: 10196372
      visit my homepage at http://grauw.blehq.org/
>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<


****
Problems? contact [EMAIL PROTECTED] See also http://www.faq.msxnet.org/
****

Reply via email to