When I specify one of these as the IrMC cable "other device", the phone wakes up with a "synchronizing" message. The multisync status reads "Getting first plugin changes...". After approximately 5 minutes, the phone reports "session failed" and multisync's IrMC log records "synchronization of 8 records succeeded". However, nothing is written by the backup plugin (which is the second plugin in my pair). After this, multisync will not connect to the phone again (reporting a "connection error"), until I replug the USB cable - I assume this is because the modem was left in an intermediate state.
Should I attempt to troubleshoot this further, or am I doing something that isn't supported by multisync? If the former, how best to gather more information what is going wrong?
Jason.
On Thu, 2005-12-15 at 16:27 +1100, Jason Grant wrote:
I have a SE K608i and would like to use multisync over USB.
I note that the connection type "cable" allows specification of "other device". I'm wondering if it is possible to somehow associate a device file with the relevant [serial] USB interface, and then refer to this device as the "other device" in the multisync UI. Does this sound plausible, and if so, how would I go about performing the preparatory step of associating the relevant USB interface with a /dev file?
Thanks,
Jason.
