Hi Michael,
Are you aware of whether your reader has the firmware for CCID ?
This is the USB specification for smart card readers and allows you
to use
the CCID driver for pcsc-lite.
Thanks,
Dave
On Jul 19, 2005, at 3:33 PM, Michael Lee Yohe wrote:
I've done all the research on the Internet I can do to try to get
these two kids to cooperate with each other. I have run into a
brick-wall.
I have a USB SCM Microsystems SCR331 smart card reader (apparently a
fairly common device). The device was loaded with the latest and
greatest firmware available from www.scmmicro.com. I have a Linux
2.6.10 based system running pcsc-lite 1.2.0. I have the SCR33x driver
from www.scmmicro.com version 4.1.1.
I installed all the files in the default paths (based on
/usr/local/pcsc). I have the manufacturer MUSCLE bundle installed
properly in /usr/local/pcsc/drivers/scr33xcciddriver.bundle. I have
commented out all the lines in /etc/reader.conf (as suggested that USB
only has no reader.conf requirement). Just in case, I modprobe'd the
scr33x kernel driver (which built with no difficulties).
# lsusb
Bus 005 Device 004: ID 2001:f103 D-Link Corp. [hex]
Bus 005 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 003: ID 04e6:e001 SCM Microsystems, Inc.
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
I checked /usr/local/pcsc/drivers/scr33xcciddriver.bundle/Contents/
Info.plist
to see if the vendor (0x04E6) and product (0xE001) IDs were present.
They were.
When I run "pcscd -a -f" I get the following:
# pcscd -a -f
debuglog.c:188 Debug options: APDU
pcscdaemon.c:251 main: pcscd set to foreground
pcscdaemon.c:445 main: pcsc-lite daemon ready.
hotplug_libusb.c:344 Adding USB device: 003:003
readerfactory.c:1391 RFInitializeReader: Attempting startup of SCR331
USB Smart Card Reader 0 0.
readerfactory.c:1133 RFBindFunctions: Loading IFD Handler 2.0
readerfactory.c:1428 RFInitializeReader: Open Port 200000 Failed
readerfactory.c:1263 RFUnloadReader: Unloading reader driver.
readerfactory.c:245 RFAddReader: SCR331 USB Smart Card Reader init
failed.
(rinse, repeat at hotplug_libusb...)
It has no problem associating 04e6:e001 with the SCR331 USB Smart Card
Reader entry in the Info.plist file. Yet, it reports a failure. I
have tested this device under Windows 2000 and XP and have no
difficulties using it.
Any thoughts?
Your help would be greatly appreciated.
--
AksanSai
_______________________________________________
Muscle mailing list
[email protected]
http://lists.drizzle.com/mailman/listinfo/muscle
_______________________________________________
Muscle mailing list
[email protected]
http://lists.drizzle.com/mailman/listinfo/muscle
