> http://www.nagravision.com/
> It should be a pay-tv card. One of the more secret cards.
> I don't think you can do anything with this card (except watch TV). In
> general, the game is to create faked pay-tv cards not try to use a
> real one.
Yes, that's right. It's used in our set-top box(STB).
I just try to do some base firmware tests now. And may be added supports under
OpenCT later.
I changed a card and readed out the ATR:
TS: 3f T0: ff TA1:95 TB1:00 TC1: ff TD1: 91 TA2: 81 TD2:71 TA3:a0 TB3:47
TC3:00
History: 44 4e 41 53 50 30 20 54 65 73 74 30 33
So, It should be a nagravision card , and there may be some unknow problems in
the former card i used.
But I got a new problem.
The TD1 in the ATR is 0x91, so only protocol T=1 is supported.
And TA1 is 0x95, that means Fi=9, Di=5,not Fd=Dd=1 any more.
And TA2 is 0x81, means that it's Specific mode.and it's bit5=0.
Then whether I needed sending PTS to select protocol T=1 after receiving ATR ?
If needed, how to send it ?
Because "ISO7816 3.4 Protocol type selection (PTS) " said "If only one
protocol type and FI=D=1 (default value of TA1) and N smaller than 255 is
indicated in the answer to reset. The transmission protocol associated to the
protocol type may be started immediately after the transmission of answer to
reset. "
So, I can't send PTS because Fi=9 and Di=5, and N=0xff.
If not, the following operations such as SELECT FILE use which F and D(Fi, Di
or Fd, Dd) ?
I did'not found clear answers in ISO7916-3 about these things. May be I shoule
read it once more.
> Oh, if you want *my* advice - I would get into pig farming rather than
> smartcard programming,
> it's a lot more rewarding and you can bring home the bacon at the end of the
> day ;-)
A ha, You have a good sense of humor. But sometimes it's no choice.
It's so long, thank you for your time.
---
Best Regards,
Bob
_______________________________________________
Muscle mailing list
[email protected]
http://lists.drizzle.com/mailman/listinfo/muscle
