On Tue, 18 Jan 2005 13:16:25 -0000, Nick <[EMAIL PROTECTED]> wrote: > Hi again, > > I'm in the UK too, so hopefully will be a similar card (is it a 990 model or > the newer 992?) > > When I used the svid connection, input 6 was the correct one (4 is the > tuner, 0 the composite which I use now) > > Therefore > > # /usr/bin/ivtvctl -p 6 > # dd if=/dev/video0 of=/dev/video16 bs=64k > > (btw did you try all 9 inputs on the card? you should get static on 4, and > prob a b+w image on 0) > > Could you send the ivtv init output from your /var/log/messages file which I > can have a check through later. Should be obvious if the card's properly > recognised and setup etc. [might as well attach your modprobe.conf as well] > Which version of the ivtv driver and firmware are you using - is this from > atrpms or have you compiled it yourself? > > Because you can see the test image from the card on the TV, I'd assume the > cable was fine (is it a switchable SCART or clearly marked for > directionality?). I remember the test_image bit would cause my card to never > get back to a clear framebuffer and needed a cold restart to clear. As you > know if works, I'd refrain from doing it during testing again to eliminate > potential probs it causes. > > It's good news that catting video0 to a file and playing back gives a > perfect video though... Was this input 6? > > Cheers, > Nick
Ok, I tried # /usr/bin/ivtvctl -p x with x from 0-9 and get an input only on 4, which seems correct as I'm using a composite input. The box my PVR-350 came in says it's a 993. I think the version of ivtv I'm using is version 0.2.0 (rc3b) from the at-testing rpms. Ive also attached my modprobe.conf and the ivtv init I get.
Jan 18 14:25:35 localhost kernel: ivtv: ==================== START INIT IVTV ==================== Jan 18 14:25:35 localhost kernel: ivtv: version 0.2.0 (rc3b) loading Jan 18 14:25:35 localhost kernel: ivtv: Linux version: 2.6.9-1.724_FC3 686 REGPARM 4KSTACKS gcc-3.4 Jan 18 14:25:35 localhost kernel: ivtv: In case of problems please include the debug info Jan 18 14:25:35 localhost kernel: ivtv: between the START INIT IVTV and END INIT IVTV lines when Jan 18 14:25:35 localhost kernel: ivtv: mailing the ivtv-devel mailinglist. Jan 18 14:25:35 localhost kernel: ivtv: Autodetected WinTV PVR 350 card Jan 18 14:25:35 localhost kernel: ivtv: Found an iTVC15 based chip Jan 18 14:25:35 localhost kernel: ACPI: PCI interrupt 0000:02:09.0[A] -> GSI 11 (level, low) -> IRQ 11 Jan 18 14:25:35 localhost kernel: ivtv: XXX PCI device: 0x5833 vendor: 0x1002 Jan 18 14:25:35 localhost kernel: tveeprom: Hauppauge: model = 48135, rev = J324, serial# = 7244454 Jan 18 14:25:35 localhost kernel: tveeprom: tuner = Philips FM1246 (idx = 24, type = 1) Jan 18 14:25:35 localhost kernel: tveeprom: tuner fmt = PAL(I) (eeprom = 0x10, v4l2 = 0x00000010) Jan 18 14:25:35 localhost kernel: tveeprom: audio_processor = CS5331 (type = 9) Jan 18 14:25:35 localhost kernel: ivtv: i2c attach [client=tveeprom[0],ok] Jan 18 14:25:35 localhost kernel: ivtv: Tuner Type 1, Tuner formats 0x00000010, Radio: yes, Model 0x00a93494, Revision 0x00000001 Jan 18 14:25:36 localhost kernel: ivtv: PAL tuner detected Jan 18 14:25:36 localhost kernel: ivtv: Radio detected Jan 18 14:25:36 localhost kernel: tuner: Ignoring new-style parameters in presence of obsolete ones Jan 18 14:25:36 localhost kernel: tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 Jan 18 14:25:36 localhost kernel: ivtv: i2c attach [client=(tuner unset),ok] Jan 18 14:25:36 localhost kernel: saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) Jan 18 14:25:36 localhost kernel: saa7115: detecting saa7115 client on address 0x42 Jan 18 14:25:36 localhost kernel: saa7115: writing init values Jan 18 14:25:36 localhost kernel: ivtv: i2c attach [client=saa7115[0],ok] Jan 18 14:25:36 localhost kernel: saa7115: status: (1E) 0x48, (1F) 0xc0 Jan 18 14:25:36 localhost kernel: saa7127: video encoder driver version V 0.3 loaded Jan 18 14:25:36 localhost kernel: saa7127: Selecting NTSC video Standard Jan 18 14:25:36 localhost kernel: saa7127: Selecting S-Video+Composite Jan 18 14:25:36 localhost kernel: saa7127: Turn WSS off Jan 18 14:25:36 localhost kernel: saa7127: Widescreen Mode 4:3 Full Format Jan 18 14:25:36 localhost kernel: saa7127: Selecting Normal Encoder Input Jan 18 14:25:36 localhost kernel: saa7127: Enable Video Output Jan 18 14:25:36 localhost kernel: ivtv: i2c attach [client=saa7127[0],ok] Jan 18 14:25:36 localhost kernel: msp34xx: ivtv version Jan 18 14:25:36 localhost kernel: msp34xx: init: chip=MSP3418W-A2, has NICAM support, simple (D) mode, simpler (G) no-thread mode Jan 18 14:25:36 localhost kernel: msp34xx: $Id$ compiled on: Jan 9 2005 06:04:05 Jan 18 14:25:36 localhost kernel: ivtv: i2c attach [client=MSP3418W-A2,ok] Jan 18 14:25:37 localhost kernel: ivtv: Encoder revision: 0x02040024 Jan 18 14:25:37 localhost kernel: ivtv: Encoder Firmware is buggy, use version 0x02040011 Jan 18 14:25:37 localhost kernel: ivtv: Decoder revision: 0x02020023 Jan 18 14:25:37 localhost kernel: ivtv: Configuring WinTV PVR 350 card with 9 streams Jan 18 14:25:37 localhost kernel: ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 0 minor 0 Jan 18 14:25:37 localhost kernel: ivtv: Create DMA stream 1 Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 1 minor 32 Jan 18 14:25:37 localhost kernel: ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 2 minor 224 Jan 18 14:25:37 localhost kernel: ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 3 minor 24 Jan 18 14:25:37 localhost kernel: ivtv: Create stream 4 Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 4 minor 64 Jan 18 14:25:37 localhost kernel: ivtv: Create DMA stream 5 using 16 65536 byte buffers 1048576 kbytes total Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 5 minor 16 Jan 18 14:25:37 localhost kernel: ivtv: Create stream 6 using 1024 2048 byte buffers 262144 kbytes total Jan 18 14:25:37 localhost kernel: ivtv: Registered v4l2 device, streamtype 6 minor 228 Jan 18 14:25:37 localhost kernel: ivtv: Create stream 7 Jan 18 14:25:38 localhost kernel: ivtv: Registered v4l2 device, streamtype 7 minor 232 Jan 18 14:25:38 localhost kernel: ivtv: Create DMA stream 8 Jan 18 14:25:38 localhost kernel: ivtv: Registered v4l2 device, streamtype 8 minor 48 Jan 18 14:25:38 localhost kernel: ivtv: Setting Tuner 1 Jan 18 14:25:38 localhost kernel: tuner: type set to 1 (Philips PAL_I (FI1246 and compatibles)) by ivtv i2c driver #0 Jan 18 14:25:38 localhost kernel: ivtv: Setting audio matrix to input 3, output 1 Jan 18 14:25:38 localhost kernel: ivtv: Switching standard to PAL. Jan 18 14:25:38 localhost kernel: ivtv: ivtv_enc_thread: pid = 2692, itv = 0xdcef52a0 Jan 18 14:25:38 localhost kernel: ivtv: ivtv_dec_thread: pid = 2693, itv = 0xdcef52a0 Jan 18 14:25:38 localhost kernel: saa7115: decoder set norm PAL Jan 18 14:25:38 localhost kernel: saa7115: set audio: 0x01 Jan 18 14:25:38 localhost kernel: saa7127: Setting Encoder Video Standard Jan 18 14:25:38 localhost kernel: saa7127: Set PAL Video Mode Jan 18 14:25:38 localhost kernel: saa7127: Selecting PAL video Standard Jan 18 14:25:38 localhost kernel: ivtv: Initialized WinTV PVR 350, card #0 Jan 18 14:25:38 localhost kernel: ivtv: ==================== END INIT IVTV ====================
modprobe.conf
Description: Binary data
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
